5-92
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter 5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8950 Switch
Figure 5-59 AC Power Supply Tray Cable (International)
Step 2 Twist the plug clockwise to secure.
Step 3 Loosen the nut on the black strain relief clamp and then slide the metal housing over the plug.
Step 4 Insert the metal tabs (located on both sides of the housing) into the slots found on either side of housing
into receptacle and then push down on the housing to secure it.
Step 5 Tighten the thumbscrew at the top of the housing by hand.
Step 6 Tighten the nut on the strain relief to secure the cable to the housing.
Step 7 Insert the other end of the cable into the wall outlet.
Step 8 If you are using a secondary (redundant) power supply, repeat Step 1 through Step 7 for the other
AC power cable.
Figure 5-60 shows the AC power connections from the back of the switch.
A
C
IN
A
C
IN
D
C
O
U
T
48455
To outlet
Slots
Captive
screw
Strain-relief nut
Tabs
