Index
IN-4
Cisco IE 3010 Switch Hardware Installation Guide
78-19581-02
SD flash memory card 1-11
overview 1-11
replacing 2-23
serial number location 4-5
setup program C-7
SFP module patch cable
description 1-6
installing 2-21
removing 2-22
SFP modules
bale-clasp latch removal 2-21
connectors B-2
installing 2-20
removing 2-21
supported 1-4
SFP module slots 1-5
short-circuit protection warning 3-8
Simple Network Management Protocol
See SNMP
SNMP network management platforms 1-14
software switch management 1-14
specifications A-1 to A-4
speed
default setting 2-25
troubleshooting 4-4
straight-through cable pinout
four twisted-pair 1000BASE-T ports B-6
two twisted-pair 10/100 ports B-6
SunNet Manager 1-14
switch models 1-1
switch models illustrated 1-2
T
technical specifications A-1 to A-4
Telnet, and accessing the CLI 1-14
temperature, operating A-1
troubleshooting
bad or damaged cable 4-2
connection problems 4-2
diagnosing problems 4-1
Ethernet and fiber cables 4-2
link status 4-2
ping end device 4-3
PoE connections 4-3
POST 4-1
serial number location 4-5
spanning tree loops 4-4
speed, duplex, and autonegotiation 4-4
switch performance 4-4
with LEDs 4-1 to 4-2
U
uninstalling the Cisco Microsoft Windows USB
driver
C-5
USB console port
overview 1-7
W
wall-mounting 2-15
Wall-Mounting the Switch 2-18
wall-mounting warning 2-15
warnings
airflow restriction 2-2
ambient temperature 2-2
EN50155 standard compliance 2-4, 2-15
ground conductor 3-5
ground connection 3-5
installation 2-1
jewelry removal 2-1
lightning activity 2-2, 3-3
national laws and regulations 2-2
PoE shock hazard 2-26
qualified personnel 2-2
restricted access areas 2-1
short-circuit (overcurrent) protection 3-8
