1-11
Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04
Chapter 1 Product Overview
Front Panel
For the most up-to-date list of supported SFP models for Cisco Industrial Ethernet switches, see
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_
6981.html#wp138176
For installation instructions, see your SFP module documentation and the “Installing and Removing SFP
Modules” section on page 2-42.
For cable specifications, see the “SFP Module Cables” section on page B-4.
Power Connectors
You connect the DC power to the switch through the front panel connectors. The switch has a dual-feed
DC power supply; two connectors provide primary and secondary DC power (DC-A and DC-B). The DC
power connectors are near the top right of the front panel. See Figure 1-1. Each power connector has an
LED status indicator.
The switch power connectors are attached to the switch chassis. Each power connector has screw
terminals for terminating the DC power (see Figure 1-5). All connectors are attached to the switch front
panel with the provided captive screws.
The power connector labeling is on the panel. The positive DC power connection is labeled “+”, and the
return connection is labeled “–”.
Commercial SFPs
32 to 158°F (0 to 70°C)
• GLC-SX-MM
• GLC-LH-SM
• GLC-BX-U with DOM support
• GLC-BX-D with DOM support
• CWDM-SFP with DOM support
• DWDM-SFP with DOM support
Extended temperature SFPs
23 to 185°F (–5 to 85°C)
• SFP-GE-S with DOM support
• SFP-GE-L with DOM support
• SFP-GE-Z with DOM support
• GLC-SX-SMD
• GLC-LH-SMD
• GLC-EX-SMD
Table 1-2 Supported SFP Models
Type of SFP Module Model
