Configuring Token Ring Inter-Switch Link
TRISL Configuration Examples
BC-154
Cisco IOS Bridging and IBM Networking Configuration Guide
78-11737-02
TRISL Configuration Examples
The following sections provide TRISL configuration examples:
• IP Routing Non-Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface
Example, page 155
• IP Routing Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface Example,
page 156
• IP Routing Source-Route Frames Between a TRISL VLAN and an Ethernet ISL VLAN Example,
page 157
• IP Routing Source-Routed Frames Between TRISL VLANs Example, page 158
• IPX Routing Non-Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface
Example, page 159
• IPX Routing Source-Routed Frames Between a TRISL VLAN and a Token Ring Interface Example,
page 160
• IPX Routing Source-Route Frames Between a TRISL VLAN and an Ethernet ISL VLAN Example,
page 161
• IPX Routing Source-Routed Frames Between TRISL VLANs Example, page 162
• SRB Between Token Ring and TRISL VLAN Example, page 163
• SRB Between TRISL VLANs Example, page 164
• Transparent Bridging Between Token Ring and TRISL VLAN Example, page 166
• SR/TLB Between a TRISL VLAN and an Ethernet Interface Example, page 167
• SR/TLB Between a TRISL VLAN and an Ethernet ISL VLAN Example, page 168
• TRISL with Fast EtherChannel Example, page 169
Note Because the VLAN Trunk Protocol (VTP) is not supported on the router configured with TRISL, the
TrCRF configuration on the router must also be specified in the Catalyst 5000 switch configuration.
