Cisco MDS 9124e Fabric Switch for HP c-Class BladeSystem 21
Checking LEDs
See Figure 6 to locate power-on LEDs.
Figure 6 Verifying power-on LEDs
Verify that the LEDs match the indicators described in Table 7.
Table 7 Power-on LEDs
Setting the IP address
Obtain the following items to set the IP address via a serial connection:
• Computer with a terminal application (such as HyperTerminal in a Windows environment or
TERM in a UNIX environment
• Null modem serial cable
Set the IP address:
1. Verify that the enclosure is powered on.
2. Identify the active OA in the BladeSystem.
3. Connect a Null modem serial cable from your computer to the serial port of the active OA.
4. Configure the terminal application as follows:
• In a Windows environment:
• Baud rate—9600 bits per second
• 8 data bits
• None (No parity)
•1 stop bit
•No flow control
Item Description
Indicators
1
UID LED
- used to help user locate a specific
module in the BladeSystem for replacement,
etc.
Off
2 Health ID LED Steady green light
:
!
EXT 1 EXT 2 EXT 3 EXT 4
1
2
181738
