Should it become necessary to ship your printer, remove any
ribbon and paper roll from the supply spools, otherwise damage
to the printer could result. Carefully pack the printer in a suitable
container to avoid damage during transit. Whenever possible, use
the original container and packaging material from the factory. If
you use a different container, a procedure similar to the original
factory packaging should be followed.
CAUTION: Do not package the printer in a rigid container
without utilizing shock mounts or shock-absorbing packing
material. A rigid container will allow shock on the outside to
be transmitted undamped to the unit, which may cause damage.
The M-Series Printer’s AC voltage may be set for either
100-120 VAC or 220-240 VAC operation. To match the printer’s
power entry selection to the available power source, refer to
Figure 2.1 and follow the procedure outlined below:
1. Locate the AC power area at the rear of the printer.
2. Using a small flatblade screwdriver or similar tool, move the
Voltage Selection switch to the 100-120 V or 220-240 V posi-
tion as re-
quired. (The in-
itial position of
the switch de-
pends on how
the printer was
ordered.) Make
sure that the ap-
propriate fuse
is in place. See
Fig. 2.1.
2-2
