Chapter 7: Second Level Commands June 30, 2006
7-18 SG1-UM-8500-03
Using the no pppoa enable command
The no pppoa enable interface command disables PPPoA negotiation for a specific interface in the system.
Usage
No pppoa enable interface <slot number>\<port number\[sub-interface number]>
For parameters see Table 7-6.
Using the interface atm command
The interface atm command defines the atm interfaces in the system.
• The command is accessible at the "configure terminal" menu.
• The command is only applicable with the SCC-ATM155 card.
• When MTU is configured to 1500, the write terminal command should not be used.
• IP address and loopback are not enabled for the PPP interface type.
• The routed type interface does not support unnumbered links.
Usage
Host(Config)# no pppoa enable interface
Host(config)# interface atm
interface atm <slot>\<port number>\<sub-interface number> [type <ppp point-to-mul-
tipoint |
routed point-to-point <ip <ip address> <mask> > |
routed-bridge <point-to-point> <ip <ip address> <mask> > | loopback <loopback inter-
face number>
routed-bridge-ppp <point-to-point> <ip [ip address> <mask> > | loopback <loopback
interface number>
]
[mtu <1500 | 1544>]
