A SERVICE OF

logo

Open as PDF
next previous
June 30, 2006 Chapter 6: First-Level Commands
SG1-UM-8500-03 6-31
Clearing Users
A specific user can be disconnected from the SG-1 by writing the clear user command followed by its line number.
Usage
clear user <line number>
Parameter(s)
<line number>
The line number of the user to be cleared.
Example(s)
Host> clear user
Note: You can use the show user command to determine the list of connected users.
Note: If the user is a multi-link user, the following message will appear: Note that multi-link users
may have other lines that are still connected.
Host> clear user 22
Note that multi-link users may have other lines that are still connected