Installing the Module 2 - 9
The Main configuration menu appears (Figure 2-2).
Figure 2-2. Main Configuration Menu
5. Refer to Chapter 3, Configuring the Module, for a description of the
configuration menus and instructions for configuring the module and
its interfaces using the configuration menus.
Once you configure the RMON MultiProbe Module and it initializes
successfully, the module begins to operate normally and monitor the
network.
Note: Hardware flow control is not active on the RMON
MultiProbe Module when you are using the configuration
menus. Depending on the Serial Port Mode setting,
hardware flow control is active when you exit the
configuration menus.
For information on the Serial Port Mode settings, refer to Chapter
3, Configuring the Module, Table 3-4 Modify/View Serial
Configuration Values Menu Description.
1 Modify/View configuration values ->
2 Download new firmware ->
3 Warm start and Exit
4 Cold start and Exit
Main menu Rev x.xx (Rev x.x)
Enter one of: 1 2 3 4 ?
