Filter
Top Products
5 En
English
The speaker and the front cover are packed separately. To
attach the front cover, line up the four salients (magnet) on the
reverse side of the front cover with the four corresponding
pegs.
• When the cover is not attached, take care not to touch
the speaker units with your hands or to exert excessive
force with tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects that
might be affected by magnets, such as TVs, clocks,
magnetic cards, diskettes etc. when you don’t attach it.
The port on the back of this unit has a port plug to adjust the
bass level. When you want to increase the bass level, detach
the port plug.
Type .................................. 2-way bass reflex speaker system
Non-Magnetic shielding type
Driver.......................................... 16 cm (6-5/16”) cone woofer
3 cm (1-3/16”) aluminum dome tweeter
Impedance ........................................................................ 6 Ω
Frequency response ......................45 Hz to 50 kHz (
– 10 dB)
to 100 kHz (
– 30 dB)
Nominal input power .......................................................30 W
Maximum input power ...................................................120 W
Sensitivity ....................................................... 88 dB/2.83 V/m
Crossover frequency ...................................................... 3 kHz
Dimensions (W x H x D)
Including terminals................................220 x 380 x 353 mm
(8-11/16” x 14-15/16” x 13-7/8”)
Speaker cabinet....................................220 x 380 x 329 mm
(8-11/16” x 14-15/16” x 12-15/16”)
Weight .......................................................... 9.7 kg (21.4 lbs.)
• Specifications are subject to change without notice due
to product improvements.
• Care should be taken not to exceed the input power
values noted above.
• A speaker cable is not included with this model.
ATTACHING THE FRONT COVER
Notes
ABOUT THE PORT PLUG
Hz
dB
50 200 300
Port plug
Rear side
without port plug
with port plug
Bass range characteristics:
Port
SPECIFICATIONS
Taking care of the speaker
When you wipe this unit, do not use chemical solvents (ex.
alcohol or thinners etc.); this might damage the finish. Use
a clean, dry cloth. For heavy dirt, dampen a soft cloth in
detergent diluted with the water, wring it out, and then clean
this unit up with the cloth.