Filter
Top Products
08905180X1 - 6 -
CONTROL COMMANDS – RC68X IR COMMANDS
The RC68+ should be set to Group Code “B9”.
Key Definition RC68X
1
Menu 80
2
Power 90
3
Up 20
4
Left E0
5
Select 48
6
Right A8
7
Down 08
8
Volume Up F0
9
Volume Down 98
10
Play/Pause 10
11
Forward A9
12
Rewind 89
13
Shuffle 68
14
Repeat C8
15
Mute 38
16
Power On C9
17
Power Off E1
18
Component Video Output 00
19
Composite Video Output C0
20
Artist 50
21
Album D0
CONTROL COMMANDS – RS232 SERIAL STRING COMMANDS
See document 089051XXX – XIS100 Serial Protocol. Available on www.xantech.com
Limited Warranty
Xantech® warrants its products to be free of defects in materials or workmanship. This is a Limited Lifetime warranty from the date of purchase by the
original consumer. Any products returned to Xantech and found to be defective by Xantech within the warranty period will be repaired or replaced, at
Xantech’s option, at no charge. Xantech will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or
consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not
apply to you. This warranty gives you specific legal rights. You may have additional legal rights that vary from state to state.
Xantech Corporation
13100 Telfair Ave. 2F, Sylmar CA 91342 | Xantech.com
Installation Instructions, XIS100 © 2008 Xantech Corporation
Document # 08905180X1
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Xantech
Corporation. Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document.