Filter
Top Products
user manual
QLight™ series
TQ series manual
page 14
Side-mounted flying strips can be fitted to the
sides of TQ-445 enclosures by removing the
countersunk bolts on the top and sides of the
cabinet and replacing them with the M10 bolts
supplied with the hardware. Two flying strips are
required for each enclosure; one attached to each
side. This method offers a simple and cost
effective way of flying single enclosures in
permanent installations. Enclosures may also be
arranged in a vertical column by coupling the
flying strips together using QL-75 quicklinks or
shackles. Turbosound flying strips are
individually load tested. When used in this way
the load is taken through the flying strips rather
than through the woodwork of the enclosure.
Side-mounted flying strips can be fitted to the sides of Qlight™ series subwoofer cabinets to
enable subwoofer enclosures to be flown as part of a permanent installation. Two different lengths
of flying strips are optionally available for flying the enclosure in either a vertical or horizontal
orientation. These are fitted by removing the countersunk bolts on the top and sides of the cabinet
and replacing them with the M10 bolts provided with the hardware. Two flying strips are required
for each enclosure. This method offers a simple and cost effective method of flying single or
multiple enclosures, with the load being taken through the steel strips rather than through the
woodwork of the enclosure. Enclosures may be arranged in a vertical column if required by
coupling the flying strips together using QL-75 quicklinks or shackles. Turbosound flying strips are
load tested.
WARNING: Rigging eyebolts must not be used for flying this enclosure. You must use the optional
Turbosound steel flying strips described above.