Filter
Top Products
user manual
NuQ series
NuQ manual
page 36
this user manual.
Small Vertical Array
A second cabinet can be suspended underneath as shown with the addition of NuQ-SBE
extender bars which are available as left and right pairs. With both HF horns rotated
through 90° from the factory-supplied orientation the combined coverage pattern will be
around 100°H x 110°V.
Using the T-bar
The NuQ-TB T-bar allows two NuQ-8 or NuQ-10 cabinets (NuQ-12 and NuQ-15 cabinets
are not compatible with the T-bar) to be mounted together in a compact horizontal array
for corporate / industrial applications—either on top of a speaker pole or tripod stand, or
suspended from a truss system using a scaffold clamp—in order to widen the available
horizontal dispersion from the speaker system for better audience coverage. The FY-PH
pole holder is a simple fitting that allows the T-bar to adapt for use with standard 35mm
speaker poles and stands.
Each cabinet can be individually rotated and angled independently.
For optimum smooth coverage the NuQ-8
and NuQ-10 should be splayed at
approximately 45° with the HF horns in the
factory-supplied orientation, which will
give a combined coverage pattern of
around 145°H x 60°V. With both HF horns
rotated for a wider vertical dispersion the
splay angle should be reduced to around
25°, giving a combined coverage pattern of
approximately 85°H x 100°V.
To create a horizontal array for speaker
stand / pole mounting:
• Assemble the flying yokes and attach them to the cabinets as detailed above
using the fixings provided with the flying yokes.
• Swing the yokes around to the bottoms of the cabinets and attach them to the
ends of the T-bar using the fixings provided.
• Attach the FY-PH pole holder to the middle of the T-bar using the screws
provided.
• Lift the assembly on to the speaker pole or tripod stand and tighten the wing
nut. Angle as required.
NuQ-TB
Tw i n Bar
NuQ-FY10
Fl y i n g Yoke
FY- PH
Pole Holder