Filter
Top Products
user manual
NuQ series
NuQ manual
page 34
Wall Mounting
NuQ cabinets can be installed using purpose-
designed Turbosound wall brackets and
OmniMount™ wall brackets from the 60 series and
120 series ranges. Please refer to the Hardware
Compatibility chart earlier in this manual for the
correct model. To install a cabinet with a Turbosound
bracket:
• Remove the blanking screws from the rear
panel of the loudspeaker (there are two M6 hex countersunk screws on the NuQ-
8 and NuQ-10, and four M6 hex countersunk screws on the NuQ-12 and NuQ-15).
• Disassemble the bracket and separate into its two component parts: the wall
plate and ceiling plate.
• Install the wall plate in the venue using suitable wall fixings, ensuring that the
plate is orientated such that the short section is at the bottom as shown.
• Assemble the speaker plate to the rear of the loudspeaker using the fixings
provided and tighten the bolts.
• Using suitable lifting equipment offer up the cabinet to the wall, insert the long
screw on the wall plate into the hole on the speaker plate, and assemble the flat
washer and nylock nut. Angle the cabinet as required and tighten the nylock nut.
All NuQ cabinets equipped with a pole mount socket can be wall mounted using the
universal PB-55 pole bracket. To install a cabinet using the PB-55 wall bracket:
• Mount the PB-55 bracket to the venue using
suitable fixings.
• Using suitable lifting equipment mount the
cabinet on to the wall bracket and tighten the
grub screw.
• Angle as required.
WB- 20B
Wall Bracket
PB-55
Pole Bracket