Filter
Top Products
user manual
LMS-D6
LMS-D6 user manual
Page 17
Gain Screen
Each output and input has an individual gain screen. The outputs have a range of +15dB to –40dB,
adjustable in 0.
..
.1dB steps and the inputs have a range of +6dB to –40dB, again
adjustable in 0.
..
.1dB
steps.
To adjust the gain:
To adjust the gain:To adjust the gain:
To adjust the gain:
Use the
‘GAIN’
‘GAIN’ ‘GAIN’
‘GAIN’
control.
X-over Sub-Menu
Press
'MENU'
'MENU''MENU'
'MENU'
and select X-over Sub-menu using the
‘BACK’
‘BACK’‘BACK’
‘BACK’
,
‘NEXT’
‘NEXT’‘NEXT’
‘NEXT’
and
'ENTER'
'ENTER''ENTER'
'ENTER'
keys. Three
options are available in this sub-menu which are:
Load a Xover
Loads a stored crossover.
Loads a stored crossover. Loads a stored crossover.
Loads a stored crossover.
Design a Xover
Opens a wizard to design a crossover. Options include format type,
Opens a wizard to design a crossover. Options include format type, Opens a wizard to design a crossover. Options include format type,
Opens a wizard to design a crossover. Options include format type,
ganging of outputs, routing and automatic limiter time constants.
ganging of outputs, routing and automatic limiter time constants.ganging of outputs, routing and automatic limiter time constants.
ganging of outputs, routing and automatic limiter time constants.
Store a Xover
Stores a X-over (all output settings) to one of 9 locations. Crossovers
Stores a X-over (all output settings) to one of 9 locations. Crossovers Stores a X-over (all output settings) to one of 9 locations. Crossovers
Stores a X-over (all output settings) to one of 9 locations. Crossovers
can be named, using the same method as memories, with up to 16 characters which
can be named, using the same method as memories, with up to 16 characters whichcan be named, using the same method as memories, with up to 16 characters which
can be named, using the same method as memories, with up to 16 characters which
appear in the default screen.
appear in the default screen.appear in the default screen.
appear in the default screen.
Security Sub-Menu
Press
'MENU'
'MENU''MENU'
'MENU'
and select Security Sub-menu using the
‘BACK’
‘BACK’‘BACK’
‘BACK’
,
‘NEXT’
‘NEXT’‘NEXT’
‘NEXT’
and
'ENTER'
'ENTER''ENTER'
'ENTER'
keys. Press
'ENTER'
'ENTER''ENTER'
'ENTER'
to load one of the four selections. (See below) A four-digit security code will then be
asked for. This can be entered by using the
‘FREQ’
‘FREQ’‘FREQ’
‘FREQ’
control, to select a character, and the
‘BACK’
‘BACK’‘BACK’
‘BACK’
and
‘NEXT’
‘NEXT’ ‘NEXT’
‘NEXT’
keys to move to the next character. Alternatively, the
‘GAIN’
‘GAIN’‘GAIN’
‘GAIN’
keys can be used to enter
a code by pressing any combination of the eight buttons. Each
‘GAIN’
‘GAIN’‘GAIN’
‘GAIN’
key represents its channel
labelling, so any combination of A, B, 1, 2, 3, 4, 5 and 6 can be used as a code.
O/P1+3 LOW
Gain = 0.1dB