Filter
Top Products
user manual
LMS-D4
LMS-D4 user manual
Page 7
Rear Panel Functions
1. Mains Power
Mains PowerMains Power
Mains Power - Connected via a standard IEC socket. A compatible power cord is supplied
with the unit.
2. Mains Fuse
Mains FuseMains Fuse
Mains Fuse - Located in a finger-proof fuseholder integral to the mains inlet. Always replace
this fuse with the correct type as shown on the rear panel legend. (N.B. A spare fuse is
located in this holder.)
3. Audio Inputs
Audio InputsAudio Inputs
Audio Inputs - 3 pin female XLR connectors are provided for each audio input. All
terminations are electronically balanced, pin 2 Hot, pin 3 Cold and pin 1 Screen (shield). The
input sensitivity is pre-set at 0db. The overall default gain of the unit is set at -14dB. Please
note that when the unit is operated in mono 3-way mode, the input signal is to be fed into the
RIGHT / MONO connector.
4. Audio Outputs
Audio OutputsAudio Outputs
Audio Outputs - 3 pin male XLR connectors are provided for each audio output. All
terminations are electronically balanced, pin 2 Hot, pin 3 Cold and pin 1 Screen (shield).
Please note that connecting to unbalanced amplifier inputs should be avoided as it will result
in a 6 dB loss of level, and limiters settings will be out by 6 dB.
STAR ROAD, PARTRIDGE GREEN, WEST SUSSEX, RH13 8RY
THIS APPARATUS MUST BE EARTHED.
DO NOT EXPOSE THIS UNIT TO MOISTURE.
DO NOT REMOVE THIS COVER.
NO USER SERVICEABLE PARTS INSIDE.
REPLACE FUSE WITH SAME TYPE ONLY.
MADE INTHE E.U.
LMS-D4
SERIAL NO.:
POWER
~ 50/60Hz 100V-240V
Fuse Sticker
OUTPUT 4 OUTPUT 3 OUTPUT 2 RIGHT / MONO IN LEFT INOUTPUT 1
PIN1=SHIELD
PIN2=HOT
PIN3=COLD
1
24 3