Filter
Top Products
5
ADJUSTING THE VOLUME
To increase the volume:
Press the • button.
To decrease the volume:
Press the• button.
When the volume is adjusted, the volume level is displayed
briey on a scale of 0 (minimum) to 20 (maximum).
SELECTING A SOURCE
You can choose to play music from a docked iPod, FM radio or
a personal audio player or other source connected to the AUX
IN jack on the rear panel.
To select a source:
Press the • SOURCE button to step through the sources.
If iPod is selected, the display will show ‘iPod’.
If FM is selected the display will show the tuned freuqency.
If the Aux input is selected, the display will show ‘AU’.
LISTENING TO THE RADIO
If FM mode is not selected, press the • SOURCE button to
select FM mode.
The tuned frequency is shown on the display and the radio will
play.
To tune to a station:
Press the • ] or [ buttons to tune the radio up or down
the band. Pressing these buttons briey will move the
frequency by one step, holding the buttons for longer
will start a search which will stop automatically at the
next station in the band.
The display will show the tuned frequency in MHz.
FM PRESETS
Your radio can store up to 10 of your favourite stations as
presets for quick recall.
To store any preset 1-10
Tune to the station you want to store as a preset.•
Press and • hold the PRESETS button.
The preset display will ash.
Press the • ] or [ button repeatedly to nd the preset
number you want to store.
Press the • PRESETS button again to conrm and store
the preset.
To browse the station presets 1-10
Press the • PRESETS button repeatedly.
The preset number playing will be displayed.
NOTE: If batteries are not tted, any stored presets will be
erased if the power is disconnected from the unit.
SOUND EQUALISER
Your docking station includes a sound equaliser with ve
dierent preset responses.
To change the sound equaliser setting:
Press the• EQ button repeatedly.
The equaliser mode selected will change in the sequence -
In the FLAT setting, no equalisation is applied.
FITTING BATTERIES
Batteries may be tted to power your docking station for
portable operation and also to provide backup power to
retain preset memories when mains power is disconnected.
To t batteries:
Slide the battery cover in the direction shown to unclip 1.
the latch. Lift o the battery cover.
Fit four ‘AA’/’UM3’ batteries into the battery 2.
compartment, observing polarity as shown.
Re-t the battery cover and slide it to lock it into place.3.
NOTE: The battery indicator will ash if there are no batteries
tted or if the battery level is low and needing replacement.
BATTERY CAUTIONS
Remove the batteries if the unit will not be used for a long
time to avoid the danger of leakage.
NOTE: Never mix old and new batteries or batteries of
dierent types. Batteries should always be replaced as sets.
Dispose of used batteries with regard to the recycling
regulations in your area. Do NOT short circuit batteries or
throw them into water, the general rubbish or in a re.
Weak batteries can leak and damage the unit. Replace them
in good time!