Tannoy DI8 DCT Portable Speaker User Manual


 
7
5. Offer the speaker up
to the K-Ball
TM
Bracket.
Push the speaker onto
the bracket to engage
the euro plug.
6. Fit the rubber
grommet and finger-
tighten the bracket bolt
while supporting the
speaker. If the
connector has engaged
properly the speaker
will lock onto the
bracket
7.Swivel the speaker
into position then use
a 19mm wrench to give
another 2
1
/
2
turns to
ensure the speaker is
locked in position.
8. Connect a secondary
support line to the
safety tab at the rear of
the cabinet.
9. Lift the grille trim
using the tab to access
the rotary transformer
tapping switch. The
rotary switch is found on
the top of the Di5
models, and on the
bottom of the Di6 and
Di8 models.
TRANSFORMER
MODELS ONLY
TRANSFORMER
MODELS ONLY
TRANSFORMER
MODELS ONLY
10. The Di5t and Di5
DCt models are fitted
with 30W transformers.
THE SPEAKER IS SUPPLIED
IN LOW IMPEDANCE MODE.
NEVER CONNECT THE
SPEAKER TO A 70/100 VOLT
AMPLIFIER WHILE IT IS SET
FOR LOW IMPEDANCE.
11. The Di6t, Di6 DCt,
& Di8 DCt models are
fitted with 60W
transformers.
THE SPEAKER IS SUPPLIED
IN LOW IMPEDANCE MODE.
NEVER CONNECT THE
SPEAKER TO A 70/100 VOLT
AMPLIFIER WHILE IT IS SET
FOR LOW IMPEDANCE.
1. If attaching the
K-Ball
TM
bracket to a
flush mounted inwall
conduit junction box
(J-box), pass the
speaker wire through the
bracket adaptor plate
then attach the adaptor
plate to the J-box using
the fixings provided.
2. Connect the speaker
wires to the connector
block in the bracket.
For connection to an
amplifier use pins 1 (+)
and 2 (-)
Pins 3 (-) and 4 (+) are
in parallel for
connection to additional
speakers in a
distributed line.
3. If a conduit junction
box has been used,
offer the bracket up to
the adaptor plate, with
the foam gasket**
squeezed in between
the J-box and the wall.
Attach the bracket to
the surface using a
suitable fixing method*.
4. If you are attaching
the bracket directly to a
surface, offer the
bracket up to the
surface with the foam
gasket** squeezed in
between. Attach the
bracket to the surface
using a suitable fixing
method*.
NOTE
* See safety notices on
page 3
** The foam gasket is
intended to provide a
water tight seal.
Inclusion of the foam
gasket is only a
requirement if
installing outdoors.
USING OPTIONAL K-BALL
TM
BRACKET
THE
USER MANUAL
RANGE
Di Manual 8-2-07 AW:Layout 1 21/2/07 10:52 Page 7