Tannoy DI6T Portable Speaker User Manual


 
8
IUSING OPTIONAL POLE MOUNT ADAPTOR
IWITH SUPPLIED YOKE BRACKET
2. Fix the pole mount
bracket adaptor to the
pole using the strapping
provided. The bracket
can be mounted in
portrait or landscape
orientations.
3. Remove the yoke
trims from the product
to access the bracket
fixing points.
4. Remove the rubber
grommet from the rear
of the speake. Inclusion
of the rubber grommet is
only required if installing
the product outdoors.
5. Feed the speaker
cable through the rubber
grommet then connect
the euro-type plug to the
wires, observing the
correct polarity.
6. For connection to the
loudspeaker, use pins 1
(+) and 2 (-)
Pins 3 (-) and 4 (+) are
in parallel for connection
to additional speakers in
a distributed line.
Note: Even if pins 3 and
4 are not used, they
should be tightend to
prevent the screws
from vibrating.
7. Offer the speaker up
to the bracket and
attach it using a 5mm
alan key and supplied
fixings.
8. Connect the euro
plug then replace the
rubber grommet to
ensure the speaker is
watertight.
9. Connect a secondary
support line to the safety
tab at the rear of the
cabinet.
TRANSFORMER
MODELS ONLY
TRANSFORMER
MODELS ONLY
10. Lift the grille trim
using the tab to access
the rotary transformer
tapping switch. The
rotary switch is found
on the top of the Di5
models, and on the
bottom of the Di6 and
Di8 models.
11. The Di5t and Di5
DCt models are fitted
with 30W transformers.
THE SPEAKER IS SUPPLIED
IN LOW IMPEDANCE MODE.
NEVER CONNECT THE
SPEAKER TO A 70/100 VOLT
AMPLIFIER WHILE IT IS SET
FOR LOW IMPEDANCE.
TRANSFORMER
MODELS ONLY
12. The Di6t, Di6 DCt,
& Di8 DCt models are
fitted with 60W
transformers.
THE SPEAKER IS SUPPLIED
IN LOW IMPEDANCE MODE.
NEVER CONNECT THE
SPEAKER TO A 70/100 VOLT
AMPLIFIER WHILE IT IS SET
FOR LOW IMPEDANCE.
1. Use the supplied
fixings to fix the yoke
bracket to the pole
bracket adaptor.
Note that the Di5 models
require 2 fixing screws
whereas the Di6 and Di8
models require 4 fixing
screws.
Di Manual 8-2-07 AW:Layout 1 21/2/07 10:52 Page 8