Filter
Top Products
Workingman’s Series Bass Speaker Enclosures • 8
WORKINGMAN’S 4X10T
Specifications
Description: 4x10 and Tweeter Speaker Enclosure
Power Handling: 400 watts RMS
Impedance: 8 ohms
Frequency Response & SPL:
100 dB SPL @ 1W1M (–3dB @ 50 Hz and 18KHz)
Speaker Complement:
(2) Custom Designed 10" SWR Drivers
(1) LCustom Designed Tweeter
Porting: Front Slot Port
Dimensions: 23"W x 25.25"H x 18.375"D
Weight: 97 lbs.
Connection and Operation
The SWR WorkingMan’s 4X10T speaker enclosure can
be connected to any musical instrument amplifier that
is capable of driving an 8 ohm load. To connect your
amplifier to the WorkingMan’s 4X10T, run a high quality speaker cable (18 gauge or heavier) from
your amplifier's speaker output to the designated 1/4" speaker input on the cabinet’s input panel.
Power Handling
The power output rating for any amplifier that is connected to the WorkingMan’s 4X10T should not
exceed the cabinet’s 400 watt power handling capacity. Please be aware that exceeding the
power handling capacity of the WorkingMan’s 4X10T can void the SWR warranty if any damage
occurs to your loudspeakers due to overpowering.
Tweeter Control Switch
(See page 3.)
Internal Crossover
The internal (passive) crossover of the WorkingMan’s 4X10T divides the incoming signal into two
frequency bands. The crossover point is 5kHz (frequencies above 5kHz are sent to the tweeter, fre-
quencies below 5kHz are sent to the 10" speakers).
Removable Caster Wheels
The WorkingMan’s 4X10T is shipped with a set of four, heavy-duty, removable caster wheels. SWR
uses only closed shaft sockets, which prevent air leaks or unwanted noise when the enclosure is in
use. To install the caster wheels on your WorkingMan’s 4X10T, carefully turn the enclosure upside
down (or on its side) so that the caster base/sockets are visible. Insert the shaft of each caster
wheel into a socket on the underside of the WorkingMan’s 4X10T. When all four wheels are firmly in
place, return the WorkingMan’s 4X10T to its upright position and you’re ready to roll. You can leave
the casters in place during performance, but it’s recommended that they be removed prior to setting
up your amplification system. This will allow your cabinet to couple to the floor, which can be helpful in
extending your system’s bass response. Please note that the ball bearing type caster wheels provided
with your WorkingMan’s 4X10T may require periodic replacement depending on usage and care.
Replacement caster wheels can be purchased from the SWR Service Department.