Filter
Top Products
Workingman’s Series Bass Speaker Enclosures • 9
WORKINGMAN’S TOWER
Specifications
Description: 8x10 and Tweeter Speaker Enclosure
Power Handling: 800 watts RMS
Impedance: 4 ohms
Frequency Response & SPL:
93 dB @ 1W1M (–3dB 60 Hz & 13.5 kHz)
Speaker Complement:
(8) Custom Designed, Stamped Steel Frame, 10" SWR
Drivers
(1) Custom Designed Tweeter
Porting: Front Slot Port
Dimensions: 46.5" H x 22.375" W x 18.25 D"
Weight: 110 lbs.
10" Speaker Specifications
Individual Impedance: 8 Ohms (each)
Power Rating: 100 Watts RMS (each)
Frame Material: Stamped Steel
Connection and Operation
The WorkingMan’s Tower can be connected to any musical instrument amplifier that is capable of
driving a 4 ohm load. To connect your amplifier to the WorkingMan’s Tower, run a high quality
speaker cable (18 gauge or heavier) from your amplifier’s speaker output to one of the designated
speaker inputs (Speakon or 1/4") on the input panel of the cabinet (see diagram, page 4).
Power Handling
The power output rating for any amplifier that is connected to the WorkingMan’s Tower should not
exceed the cabinet’s 800 Watt power handling capacity. Please be aware that exceeding the
power handling capacity of the WorkingMan’s Tower can void the SWR warranty if any damage
occurs to your loudspeakers due to overpowering.
Full Range Input and Output Jacks
The WorkingMan’s Tower features four, full range input/output jacks (two standard 1/4" and two
Speakon
®
) wired in parallel (see diagram, page 4). If you are running two speaker enclosures in
parallel, connect the speaker cable from your amplifier to either jack labeled “IN,” and a second
speaker cable from either jack labeled “OUT” to the input of the second speaker enclosure.
Speakon
®
Jacks
Whenever possible, use of the Speakon jacks is recommended. Speakon jacks and connectors
offer the best possible connection and are far superior to banana or 1/4" phone jacks in that they
not only lock in place (preventing accidental disconnection), but also offer a greater and more sta-
ble connection surface. This solid connection provides a more effective transfer of power to your
speakers, particularly from high-powered amplifiers.
(continued)