Filter
Top Products
Instruction Manual
3
Hardware Installation
1. Turn o the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCIe slot.
4. To install the card, carefully align the card’s bus connector with the selected PCIe slot on
the motherboard. Push the board down rmly.
5. Optional: Connect the LP4 molex power connector from the computer power supply to
the card. Make sure the Jumper settings on the card are congured properly.
6. Replace the slot bracket’s holding screw to secure the card.
7. Replace the computer cover and reconnect the power cord.
Driver Installation
Windows 2000/XP Driver Installation
1. At the Add New Hardware Wizard window, click on “Next.”
2. Select the option “Search for the best driver for your devices (Recommended)” and click
on “Next.”
3. Select the option “Specify the location” and type in D:\Uart (where D: is your CD-ROM
drive) then click on “Next.”
4. Click “Next” and then “Finish” respectively.
5. Remove the disc, then select “Yes” to restart the computer for the setup to take eect.
To verify successful installation on Windows 2000/XP:
1. From the main desktop, right-click on “My Computer”, then select Manage. In the new
Computer Management window, select “Device Manager” from the left window panel.
2. Double-click on both “Ports (COM & LPT)” and “Multifunction Adapters”. The Serial
Adapter board and additional serial ports (COM ports)should be displayed when
successfully installed. The port is ready to be connected to new device(s).