Filter
Top Products
Recording 27
GB
Recording
To pause recording
Press MD ^. Press the button again to resume
recording. (On the remote, use MD P instead of MD
^.)
Recording from a CD
Track marks on the source CD are recorded on the
same positions on the MD. Track marks are also added
automatically on the MD when you pause recording.
If unnecessary track marks are added, erase them after
recording (see ”Combining recorded tracks” on page
36).
1 Insert a CD.
2 Press CD p to activate the CD player.
3 Insert a recordable MD.
4 Press REC (r on the remote).
Recording does not start (recording standby
mode).
5 Press MD ^ (MD ( or MD P on the remote).
Recording will be made from the last recorded
position.
6 Press CD ^.
To stop recording
Press MD p.
To pause recording
Press MD ^. Press the button again to resume
recording. (On the remote, use MD P instead of MD
^.)
Tip
When you record a
program of a station
whose name is labeled
on this player, the
station name is
recorded automatically
as the track name (page
21).
Notes
• After you
stop
recording,
do not disconnect the
AC power cord or
move the player
while “TOC EDIT” is
flashing in the
display. If you do so,
recording may not be
done properly.
• If you turn up the
volume too high,
sound skipping may
occur.
Tips
• To add track marks
during recording, press
REC where you want
to add track marks.
• To record over the
previous recording, see
page 28.
• To add track marks
after recording, see
“Dividing recorded
tracks” on page 34.