Filter
Top Products
Power Sources 25
EN
Power Sources
( Power Sources
Replacing the batteries
Battery
compartment
lid
Display
HOLD/PUSH OPEN
1 Remove the battery holder. (See page 4.)
2 Replace the batteries with new ones in the battery
holder. (See page 4.)
3 Make sure that all indicators disappear in the
display.
4 Insert the battery holder into the tape-corder and
close the lid. (See page 4.)
When to replace the batteries
The status of the remaining battery power is
displayed when the batteries are used.
Battery full.
Replace all four batteries with new
ones.
“
” flashes and the tape-
corder enters the stop mode when
used beyond this point.
Battery life
(Approx. hours)
Battery Playback Recording
(in the recording
monitor mode)
Sony alkaline (size AA) 3.5 3 (4*)
Sony rechargeable (size AA) 2 1.5 (2*)
Values for battery life at 20°C.
Battery capacity decreases and battery life becomes
shorter in low temperatures.
* When no plug is connected to the PHONES/LINE
OUT jack.
Tips
• This tape-corder is not
equipped with a power
switch. As a result, the
LCD display will
always be turned on as
long as the batteries are
inserted. However,
power consumption is
minimal and negligible.
• Especialy when the
tape-corder is in the
low-power
consumption mode, all
indicators do not
disappear in the
display immediately
after removing the
battery holder from the
tape-corder. Cancel the
low-power
consumption mode
before removing the
battery holder. If the
batteries are replaced
before all indicators
disappear in the
display, the remaing
battery power may not
be displayed correctly.
• The clock will return to
its default setting (SU/
95Y1M1D/
AM12H00M00S) if the
batteries are removed
from the tape-corder
for one hour or more.
In this case, set the
clock again.
Note
Remove the batteries
when the tape-corder is
not to be used for an
extended period of time.