Filter
Top Products
7
Basic Operations
1 Turn on the amplifier and set the
source selector to the recorder.
2 Press POWER.
3 Press A and place a disc on the inner
circle of DECK A (or B). Press A again
to close the disc tray.
4 Press H.
The recorder starts playing. Adjust the
volume on the amplifier.
AMS ./>
Playing a CD
This recorder has two decks. When using the
remote, set SELECT to CD for operations on
DECK A (the CD player section), or to CDR
for operations on DECK B (the CD-R or CD-
RW recording section).
In this manual, the CD player section is just
called DECK A, and the CD-R and CD-RW
recording section is called DECK B.
Basic Operations
POWER OPEN/CLOSE A
H
With the label side up
To
Stop playback
Pause playing
Select a track
Go to the
beginning of the
current track or
the preceding
track
Take out the disc
* AMS: Automatic Music Sensor
Tips
You can start playing with the track selected in Step
4.
1Press AMS . or > (or press . or > on
the remote) to select the track you want to play
using the display*.
2Press H.
*See “Using the Display” on page 8.
Tips
You can remove and load discs while playing another
disc. Press A of the deck that is not currently playing
to open that tray, and remove or load a disc.
Notes
• You can play unfinalized CD-R or CD-RW discs
only in DECK B. If you attempt to play an
unfinalized disc in the DECK A, a DISC ERROR
message will appear to remind you to play the disc
in DECK B. For the detailed explanation about
finalizing, see “Finalizing a CD-R or CD-RW disc”
on page 19.
• At the end of a listening session, remove the discs
from the decks by following the instructions in step
3. Do not leave the disc tray open when the unit is
not in use to prevent dust and dirt from entering the
unit and to prevent damage to the disc tray.
Do the following:
Press x.
Press X. Press the button again or
press H to resume playing.
Press AMS* >.
Press AMS ..
Press A on DECK A or B, which
ever contains the disc you want to
remove after stopping play.
CD/CDR
select