Filter
Top Products
The Timer22
6 Press TUNE TIME SET + or – to set the volume,
then DSPL ENT MEM.
7 Press STANDBY.
The c indication lights up and the power goes off.
At the preset time, the power will go on, and the
music will play. Then the power will go off at the
preset time, and the player will enter into the
standby mode.
To check/change when the playback will start
Press TIMER, then DSPL ENT MEM. Each time you
press DSPL ENT MEM, a stored setting is displayed in
the set order. To change the setting, display the setting
you want to change and re-enter it.
To use the player before a timer playback starts
Just turn on the player, and then you can use it.
If you turn off the player before the preset time, timer
playback will start at the preset time.
In case of the radio, however, if you listen to the
station which is different from the one you tuned in
in step 1 on page 21, you will hear that station at the
preset time. Make sure to tune in the station you want
to listen to before you turn off the player.
To stop play
Press POWER to turn off the power.
Tips
• To exit the standby
mode, press STANDBY
to make c disappear
from the display.
• The preset settings
remain until you reset
them.
Note
When you press N or
z button of the tape
player in the timer
mode:
If the tape length of
one side is longer than
the set time, the player
will be turned off at the
end of the tape, not at
the set time.
Waking up to music (continued)