Filter
Top Products
The Timer20
Before you set the clock, connect the power source (see
page 26).
1 Press CLOCK for 2 seconds until the hour digit
flashes.
2 Press TUNE TIME SET + or – until you set the
current hour. Then press DSPL ENT MEM.
The minute digits flash. Set the minutes by
pressing TUNE TIME SET + or – until the correct
minute is displayed.
3 Press DSPL ENT MEM.
The clock starts from 00 seconds.
Setting the clock
“– –:– –” indication appears in the
display until you set the clock.
The Timer
Tip
The time display
system:
12-hour system
AM 12:00 = midnight
PM 12:00 = noon
,
CLOCK
DSPL
ENT MEM
TUNE
TIME SET –, +