Filter
Top Products
27
Symptom
The CD does not play or
“Nodisc” appears in the
display when a CD is placed
in the CD player.
CHARGE lamp flashes on the
CD player when you press a
button, and the CD does not
play.
Cannot adjust the volume
with VOL +/– on the CD
player.
During recording with optical
digital connection, the track
number cannot be recorded
correctly.
The rechargeable batteries
cannot be charged.
Cause and/or corrective actions
c The buttons are locked. Slide the HOLD switch back. (page 16)
c The CD is dirty or defective. (page 24)
c Check that the CD is inserted with the label side up. (page 7)
c Moisture condensation has occurred.
Leave the CD player aside for several hours until the moisture
evaporates.
c Close the lid of the battery compartment firmly.
(page 19)
c Make sure the batteries are inserted correctly. (pages 19, 22)
c Connect the AC power adaptor to an AC outlet securely. (page 7)
c The CD-R/CD-RW was not finalized. Finalize the CD-R/CD-RW
with the recording device.
c There is a problem with the quality of the CD-R/CD-RW,
recording device, or application software.
c The buttons are locked. Slide the HOLD switch back. (page 16)
c The CD player is connected to an audio device. Adjust the volume
using the volume control on the connected device. (page 18)
c Record the track number again using a MiniDisc recorder, DAT
recorder, etc. (page 18)
c See the instruction manual that comes with the recording device.
(page 18)
c
The terminals on the CD player or the charging stand are dirty.
Wipe them with a dry cloth.
c The CD is playing. Stop playing.
c The external battery case is connected to the CD player. Remove it
and start charging again.
c The CD player is not placed securely on the charging stand. Place
the player on the stand, aligning the V mark on the player and the
v mark on the stand. Make sure that the CHARGE lamp lights up.
(page 19)
Additional information
(Continued)