Filter
Top Products
36
Troubleshooting
Symptom
CHARGE lamp
flashes on
the CD player when you
press a button, and the
CD does not play.
Cannot adjust the volume
with the VOL +/– buttons
on the CD player.
During recording with
optical digital
connection, the track
number cannot be
recorded correctly.
The CD player does not
start charging.
Playback starts from the
point you stopped.
(resume function)
Rustling noise is heard
from the CD.
When closing the lid of
the CD player, the CD
starts to rotate.
You cannot operate the
CD player properly using
the remote control.
Cause and/or corrective actions
c The buttons are locked. Slide the HOLD switch back.
c The CD player is connected to an audio device. Adjust the volume using
the volume control on the connected device.
c Record the track number again using a MiniDisc recorder, DAT
recorder, etc.
c See the instruction manual that comes with the recording device.
c During stop, press x/CHARGE.
c You pressed x on the remote control. Press x/CHARGE on the CD
player.
c The resume function is working. To start playing from the first track,
turn the rotary control on the remote control toward N/> and hold it
until the first track starts playing (press > N for 2 seconds or more
for the CD player), or open the lid of the CD player. Or, remove all
power sources, then insert the batteries or connect the AC power adaptor
again.
c Close the lid of the battery compartment firmly.
c The CD player is reading the information on the CD. It is not
malfunctioning.
c The buttons on the CD player are kept pressed by mistake.