Filter
Top Products
35
English
Troubleshooting
Should any problem persist after you have checked these symptoms, consult your nearest Sony
dealer.
Symptom
Cannot adjust the volume
by turning the rotary
control on the remote
control.
Cannot start play by
turning the rotary control
on the remote control.
The volume does not
increase even if you
press the VOL + button
repeatedly.
Cannot adjust the
volume.
No sound, or noise is
heard.
The playing time is too
short when powered with
the dry batteries.
The playing time is too
short when powered with
the rechargeable
batteries.
“Lobatt”
or “00” appears
in the display. The CD
does not play.
“HiDCin” appears in the
display.
The CD does not play, or
“Nodisc” appears in the
display when a CD is
placed in the CD player.
Cause and/or corrective actions
c Pull the rotary control in the direction of the arrow indicated on the
control, then turn the control toward VOL + or –.
c The rotary control is pulled out. Push the control back, then turn the
control toward N/>.
c Set the AVLS switch to “NORM.”
c The earphones are connected to the LINE OUT (OPTICAL) jack.
Connect them to the i (headphones) jack.
c The earphones are connected to the LINE OUT (OPTICAL) jack.
Connect them to the i (headphones) jack.
c Connect the plugs firmly.
c Plugs are dirty. Clean the plugs with a dry soft cloth periodically.
c Check that you are using alkaline batteries and not manganese batteries.
c Replace the batteries with new LR6 (size AA) alkaline batteries.
c Charge and discharge the rechargeable batteries several times.
c The rechargeable batteries are used up completely. Charge the batteries.
c The dry batteries are used up. Replace them with new LR6 (size AA)
alkaline batteries.
c Use only the supplied AC power adaptor or optional AC power adaptor.
c Use only the optional car battery cord.
c Remove all power sources, then insert the batteries or connect the AC
power adaptor again.
c The buttons are locked. Slide the HOLD switch back.
c The CD is dirty or defective.
c Check that the CD is inserted with the label side up.
c Moisture condensation has occurred. Leave the CD player aside for
several hours until the moisture evaporates.
c Close the lid of the battery compartment firmly.
c Make sure the batteries are inserted correctly.
c Connect the AC power adaptor to an AC outlet securely.
c The CD-R/CD-RW was not finalized. Finalize the CD-R/CD-RW with
the recording device.
c There is a problem with the quality of the CD-R/CD-RW, recording
device, or application software.
(Continued)