Filter
Top Products
36
Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
BLANK • An MD with no recording on it is inserted.
, Insert a recorded MD.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take
2–3 minutes).
Edit • The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the
player to physical shock, nor disrupt power supply.
ERROR • The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. If this fails, rerecord.
FULL • There is no more space to record on the disc (less than 12
seconds in stereo, 24 seconds in LP2 stereo mode or monaural
or 48 seconds in LP4 stereo mode available).
, Replace the disc.
• You tried to enter more than 200 letters to label a single track
or disc.
• You tried to enter a total of more than 1,700 letters for track or
disc names during playback or stop.
, Enter a shorter name for track or disc, or delete “LP:” from
the beginning of the track name recorded in MDLP mode
(page 26).
HiDCin • Voltage of the power supply is too high (The recommended
AC power adaptor is not used).
, Use the recommended AC power adaptor.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 25).
LoBATT • Battery is weak.
, Replace the dry battery (page 9).
MEMORY • You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording
again.