Filter
Top Products
32
Symptom
Cannot adjust the volume
with the VOLUME +/– buttons
on the player.
No picture appears on the TV
screen.
Picture is distorted.
Picture is distorted or blurred
or becomes monochrome.
Picture is distorted, noise is
heard or playback stops.
The wireless remote control
does not function.
The CD player does not start
charging.
Cause and/or corrective actions
c
The player is connected to an audio device. Adjust the volume
using the volume control on the connected device.
(page 8-11)
c Make sure the TV is turned on.
c Make sure you select the correct video input on the TV.
c Connect the video connecting cord correctly.
c An audio CD is being played.
c Close the lid of the player and the battery compartment firmly.
c Make sure the following mark is on the VIDEO CD.
c You may not play back some illegally duplicated VIDEO CDs
even though they have the above mark printed. In this case, consult
the shops where you bought the VIDEO CDs
c When you pause or use search, picture is distorted. This is not a
malfunction.
c The VIDEO CD is defective. Replace the VIDEO CD.
c The VIDEO CD is dirty. Clean the VIDEO CD.
c The color system you have selected for this player is not the same
as the one the VIDEO CD is recorded with. (page 7)
c The setting of the NTSC/PAL switch does not match the color
system of the TV. Check the setting. (page 7)
c Move a portable telephone, transciever, etc. away from the player.
c If 5 minutes have already passed after you turned off the player by
pressing x, you cannot turn on the power using the wireless
remote control. In this case, press u on the player to turn on the
power. Once the player is turned on, you can operate the player
with the wireless remote control. (Only when using the player on
alkaline batteries)
c Remove any obstacles between the wireless remote control and the
remote sensor. (page 12)
c Replace all the batteries in the wireless remote control with new
ones if they are weak.
c
During stop, press
x
/CHG. (page 27)
Troubleshooting