Filter
Top Products
1
CONNECTION DIAGRAM
volume
m1
m2
pitch
xyz
-
+
octave
accomp
store
tap
phrase
latch
analog modeling synth
push
r
h
y
t
h
m
s
p
a
t
t
e
r
n
s
p
r
o
g
r
a
m
s
s
e
t
u
p
s
c
o
n
f
i
g
• Connect your electronic drum set's triggers to the corresponding inputs on the module with the
appropriate 1/4" cables. Dual-zone pads or cymbals
(e.g., a drum with head and rim triggers or a
cymbal that can produce bow and bell sounds) will require TRS cables to trigger both zones.
• Plug 1/4” TRS cables from the MAIN OUT or AUX OUT to an amplifier, mixer, or speaker system. (For
mono sound, you can connect only one output.)
• You can connect a set of 1/4” TRS headphones to the HEADPHONES OUTPUT.
• You can connect another audio device to the AUX IN using standard RCA cables.
IMPORTANT: THE DM10 MODULE MAY BE AFFECTED BY STATIC ELECTRICITY. IF THIS
OCCURS, SIMPLY TURN THE MODULE OFF AND WAIT AT LEAST A FEW SECONDS BEFORE
TURNING IT ON AGAIN.
NOTE: Out of the box, the DM10 module is write-protected, so you will be unable to save any changes
you make to the Kits, Instruments, Sequences, etc. To turn write protection off:
1. Press UTILITY.
2. Press SYS (F4).
3. Press O/S (F3).
4. Press MEM (F4).
5. Press VALUE DOWN or move the VALUE DIAL counterclockwise until the "WriteProt" field
says "OFF."
6. Press DRUM KIT to return to the main page.
See the included assembly poster for further instructions on setting up the DM10
K
it and connecting it to
the DM10 module.
POWER
COMPUTER
CD PLAYER
MONITORS
HOUSE AMP
EXTERNAL MIDI MODULEDRUM KIT MIDI KEYBOARD
WARNING
:
Use only the
included Alesis
power supply
with the DM10
module.