Filter
Top Products
8
Setting up and connecting
SKRD 30 A1
GB
IE
Disposal of the packaging
The packaging protects the device from transport damage. The packaging ma-
terials are selected from the point of view of their environmental friendliness and
disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces generated waste. Dispose of packaging material that is no longer
needed according to the regionally established regulations.
NOTICE
If possible preserve the device's original packaging during the warranty ►
period so that in the case of a warranty claim you can package the device
pr
operly for return.
Set-up location requirements
For the safe and fault free operation of the device, the set-up location must fulfi ll
the following conditions:
When setting up the device place it on a fi rm, fl at and even surface. Use the ■
supplied stand.
Set up or mount the de
vice in such a way that the available ventilation open- ■
ings and the speak
er are not covered.
Do not operate the device in a hot, wet or very humid location or in the vicin- ■
ity of fl ammable materials.
The sur
faces of furniture may contain components that could aff ect and sof- ■
ten the rubber feet on the device. If necessary, place an anti-slip mat under
the rubber feet of the de
vice.
The wall socket must be easily accessible so that, in an emergency, the plug ■
can be quickly withdrawn from the socket.
Electrical connection
Before connecting the device, compare the connection data (voltage and ■
frequency) on the rating plate of the device with that of your power supply
network. This data must be compatible to avoid possible damage to the device.
Make sure that the device's connection cable is not damaged and is not ■
laying over hot surfaces and/or sharp edges.
Mak
e sure that the connection cable is not tightly stretched or bent. ■
Do not allow the connection cord to hang over edges (Trip wire eff ect). ■