Filter
Top Products
- 5 -
Fixing the kitchen radio beneath a
wall cabinet
With the supplied mounting plate q you can
x the kitchen radio below, for example, a
kitchen wall cabinet:
1. Determine a suitable location for the
kitchen radio.
2. Press the two retaining levers on the back
of the appliance down. Push the mounting
plate q back and remove it.
3. Hold the mounting plate q under the in-
stallation location. Thereby, the front edge
of the mounting plate q should be ap-
prox. 4 cm behind the front of the kitchen
cabinet (See fold-out illustration "B").
4. Mark the four points for the drillholes with
a pencil.
5. Using a spike, make a small depres-
sion at the marking points. Firmly secure
the mounting plate q with the supplied
screws.
6. Hold the kitchen radio slanted, with the
two recesses in the retaining lugs on the
mounting plate q. Press the kitchen radio
upwards until it perceptibly engages.
Disassembly
• To disassemble the kitchen radio, press
the two retaining levers at the rear of the
appliance downwards. Then pull the ra-
dio out to the front and remove it.
• Unscrew the screws and remove the as-
sembly plate q.
Setting up the kitchen radio
Do not set the kitchen radio up without the
mounting plate q. Otherwise the speakers are
covered and the sound is scarcely audible.
To t the kitchen radio with the supplied
mounting plate q:
1. Simultaneously press the two retaining
levers on the back of the appliance down.
Push the mounting plate q back and re-
move it.
2. Push the two rear retainer lugs on the
mounting plate q into the recesses on the
lower side of the kitchen radio.
3. Press the mounting plate q rmly into the
appliance underside until it perceptibly
engages.
Providing mains power
• When you have completed installation of
the appliance, insert the plug into a mains
power socket. The display o is illumi-
nated and the appliance tries to receive
an RDS signal to automatically adjust
the time and date.
• For as long as the appliance waits for
the RDS signal, the display o shows
"Please wait for setting thanks". This
can take several minutes. To hide this no-
tice, press the button MODE/
j.
The Settings menu
Setting the time
Should this not succeed, you must set the
clock manually. For this, the radio cannot be
switched on (= automatic mode).
1.
In automatic mode press the button
MODE/
j once. The time display
blinks.
2.
Press the buttons UP/DOWN 1(/l
to set the time in minute intervals. Pressing
and holding the button changes the time
at ten-minute intervals.
3.
Press the button MODE/ j once
again to save the time and switch to the
date setting.
If you do not press a button for 15 seconds
when making the settings, the appliance saves
the current setting and returns to automatic
mode.
Setting the date
1. In automatic mode press the button
MODE/ j twice. In the display o
appears "01.01.2010", the date display
ashes.
BDA_KH 2398 - DT-49029_6_uk.indd 5 22.06.2010 17:28:47