Filter
Top Products
- 7 -
Fixing the kitchen radio beneath a wall cabinet
Caution:
The following described procedures must only be car-
ried out by persons with corresponding experience
since if they are carried out incorrectly it can lead to
device damage and/or cupboard surface damage.
With the supplied mounting plate q you can x the kitchen
radio below, for example, a kitchen wall cabinet:
1. Determine a suitable location for the kitchen radio.
2. Press the two retaining levers on the back of the appliance
down. Push the mounting plate q back and remove it.
3. Place the mounting plate q against the installation loca-
tion. Allow 4,5 cm space to the front edges.
This way the kitchen radio will later t ush.
4. Mark the four points for the drillholes with a pencil.
5. Using a spike, make a small depression at the marking
points. Firmly secure the mounting plate q with the sup-
plied screws.
6. Hold the kitchen radio slanted, with the two recesses
in the retaining lugs on the mounting plate q. Press the
kitchen radio upwards until it noticeably engages.
Disassembly
To disassemble the kitchen radio, press the two retaining
•
levers at the rear of the appliance downwards. Then pull
the radio out to the front and remove it.
Unscrew the screws and remove the assembly plate
• q.
Setting up the kitchen radio
Do not set the kitchen radio up without the mounting plate q.
Otherwise the speakers are covered and the sound is scarcely
audible.
To t the kitchen radio with the supplied mounting plate q:
1. Simultaneously press the two retaining levers on the back
of the appliance down. Push the mounting plate q back
and remove it.
2. Push the two retainer lugs on the mounting plate q into
the recesses on the lower rear side of the kitchen radio.
3. Firmly press the front part of the mounting plate q down
until you hear it engage. You can now set up the radio.