Silvercrest KH 2289 Clock Radio User Manual


 
- 5 -
Fixing the kitchen radio beneath
a wall cabinet
With the supplied mounting plate
q
you can fix
the kitchen radio below, for example, a kitchen wall
cabinet:
1. Determine a suitable location for the kitchen
radio.
2. Press the two retaining levers on the back of
the appliance down. Push the mounting plate
q
back and remove it.
3. Place the mounting plate
q
against the instal-
lation location. Allow 3,5 cm room to the front
edges. This way the kitchen radio will later
fit flush.
4. Mark the four points for the drillholes with a
pencil.
5. Mark the drillhole with a mandril.
6. Firmly secure the mounting plate
q
with the
supplied screws.
7. Place the kitchen radio diagonally with the two
recesses in the retainer lugs of the mounting
plate
q
. Press the kitchen radio up until you
hear it engage.
Note:
Secure the wire antenna with a piece of adhesive
tape such that it does not hang down.
Disassembly
To disassemble the kitchen radio, press the two
retaining levers at the rear of the appliance
downwards. Then pull the kitchen radio forewards
to remove it.
Unscrew the screws and dismantle the mounting
plate.
Note:
Replace the mounting plate onto the radio as
described in the following section.
Setting up the kitchen radio
Do not set up the kitchen radio without the mounting
plate
q
. Otherwise the speakers are covered and
the sound is scarcely audible.
To set up the kitchen radio with the enclosed
mounting plate
q
:
1. Simultaneously press the two retaining levers
on the back of the appliance down. Push the
mounting plate
q
back and remove it.
2. Push the two retainer lugs on the mounting
plate
q
into the recesses on the lower rear
side of the kitchen radio.
3. Firmly press the front part of the mounting plate
q
down until you hear it engage. You can now
set up the radio.
To disassemble the mounting plate
q
, grip the
mounting plate
q
from below with the thumbs and
press it forwards and up until it disengages. You can
now remove the mounting plate
q
.
IB_KH2289_DT33485_LB6.qxd 18.06.2009 12:16 Uhr Seite 5