Filter
Top Products
04/1/28 DKCL6N_EN
11
Listening to the radio (continued)
You can store 10 AM and 10 FM stations in memory and recall them
at the push of a button. (Preset tuning)
Note:
The backup batteries function protects the memorized stations
should there be a power failure or the AC power cord becomes
disconnected. If the backup batteries are drain off, the memorized
stations will be erased.
Press the or button for less than 0.5 seconds to select the
desired station.
Alarm and sleep operation
The unit turns on and play desired source (iPod or TUNER) or
Buzzer sound for 1 hour alarm cycle.
Before setting the alarm:
Setting the alarms
In this example, the setting is for ALARM 1. The same method is
used to set for ALARM 2.
Note:
If wake up source is set to iPod, and iPod is not present, the alarm
source will change to default Buzzer.
Caution:
During alarm activation, sound will be not output to the speaker if
headphones is plugged in. Make sure to unplug the headphones if it
is not used.
Volume auto fade-in (Alarm mode)
● If turn off the main unit with the volume set to lower than Vol 16,
the wake up alarm volume will start at last set level and fades
into the Vol 16.
● If turn off the main unit with the volume set to higher than Vol 16,
the wake up alarm volume will starts at Vol 16 and fades into the
last set level.
■ Memorizing a station
1 Perform steps 1 - 4 in “Tuning” on page 10.
2 Press the EQUALIZER/-PROG button for more than 2
seconds on the main unit or remote control (DK-CL6N only)
to enter the preset tuning saving mode.
3 Within 1 minute, press the or button to select the
preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 1 minute, press the EQUALIZER/-PROG button on
remote control to store that station in memory.
If the preset number indicators disappear before the station
is memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station
previously memorized for that preset channel number will be
erased.
■ To recall a memorized station
■ Alarm
1 Check that the clock is set to the correct time. (refer page 8)
If it is not set, you cannot use the alarm function.
2 For iPod playback: Insert iPod to the unit. (refer page 9)
3 For TUNER: Set preset memory. (refer left)
1 Press and hold the ALARM 1 button until the alarm time flashing.
2 Press the TUNING/SET ( or ) button to adjust the hour and
then press the ALARM 1 button.
Press the TUNING/SET ( or ) button once to advance the
time by 1 hour. Hold it down to advance continuously. “AM” or
“PM” indicator will interchange after each 12 hour cyclic.
3 Press the TUNING/SET ( or ) button to adjust the minutes
and then press the ALARM 1 button.
Press the TUNING/SET ( or ) button once to advance the
time by 1 minute. Hold it down to change the time in 5 minutes
interval.
4 Press the TUNING/SET ( or ) button to select the wake up
source and then press the ALARM 1 button.
Wake up source:
Two beeps will indicate alarm setting is complete.
MON
BUZZER RADIO iPod