Learn More, Service, and Warranty Information
24
9. General. This Agreement contains the entire understanding between the parties with respect to
your use of the Software. If any part of this Agreement is found void and unenforceable, it will not affect the
validity of the balance of this Agreement, which shall remain valid and enforceable according to its terms. This
Agreement is governed by and construed under the laws of the State of California and controlling U.S.
federal law without regard to conflicts of laws provisions thereof. The U.N. Convention on Contracts for
the International Sale of Goods shall not apply to this Agreement. Any action or proceeding arising from
or relating to this Agreement shall be adjudicated in the state or federal courts of Santa Clara County,
California, and the parties hereby agree to the exclusive jurisdiction and venue of such courts. You will
not remove or export from the United States or re-export from anywhere any part of the Software or any
direct product thereof to any country in violation of U.S. Export Administration Regulations, or a successor
thereto, except in compliance with and with all licenses and approvals required under applicable export
laws and regulations including, without limitation, those of the U.S. Department of Commerce. Any
waivers or amendments of this Agreement shall be effective only if made in writing and signed by an
authorized representative of each party. You agree that the Licensors are third party beneficiaries of this
Agreement to enforce your performance of the terms and conditions of this Agreement. The provisions of
Sections 2, 3, 4, 5, 6, 7, 8 and 9 shall survive the termination or expiration of this Agreement.
FCC Regulation
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and then on, the user is
encouraged to try to correct the interference by one or more of the following measures:
1. Increase the separation between the equipment and receiver.
2. Correct the equipment to a different outlet so that the equipment and receiver are on
different branch circuits.
3. Consult the dealer or an experienced radio / TV technician for help.