Filter
Top Products
13
Connecting yepp to PC
12
Before connecting yepp to PC, make sure to install
USB driver. If “Add New Hardware Wizard” appears, press
the [Cancel] button and install USB driver.
System Requirements.
● Pentium 133MHz or greater
● Windows 98 SE/ME/2000/XP
● 20MB of available hard disk space
● CD-ROM drive
(double speed or greater)
● USB port (1.1) supported
● VGA graphic
Installing software
Insert the Installation CD into CD-ROM drive.
The picture shown below appears.
Select [USB Driver Install].
1
Click [Next] in the series of windows
that appear.
2
When installation is completed,
connect yepp to PC and use it
as shown on the next page.
Continued...
N
N
o
o
t
t
e
e
:
:
● Install the operating system in
Administrator Account mode for Windows
2000 or XP. Otherwise, installation will not
be completed.
● Windows ME, 2000 and XP can
recognize the driver without installing the
provided program. However, you must
install the program in order to format yepp
and upgrade firmware.
●
If the YP-35 program has not been
installed in Windows 98, then it will not
communicate with your removable disk.
You must install the USB driver file
first.
35-eng-can(5/23) 5/27/03 2:10 PM Page 12