Filter
Top Products
4.11
CHAPTER FOUR
Special Features
4
4
Programming the Remote Control for Other Components
The remote control is pre-programmed to operate your Set-Top Box. However, you can
also program the remote control to operate other components, such as a cable TV box, a
VCR or a DVD (even if they are made by a manufacturer other than Samsung).
1
Press the SELECT button on order to activate the appropriate com-
ponent (VCR, TV, Cable, DVD, etc.)
For example, if you are programming the remote control to
operate your VCR, press SELECT on the remote control so that
the VCR indicator is illuminated.
2
Press the SET button on the remote control. The LED for the active
component will light for 30 seconds. While the LED is illuminated,
use the number buttons to enter the code number for the particular
manufacturer (see table, on page 4.12~4.14).
Each code numbers must be three digits long. For example, to
enter the code “6,” press 0, 0 and 6. To enter the code “76,”
press 0, 7 and 6.
If the number is correct, the indicator will blink three times. If the
indicator does not blink three times, repeat step1,2 and try
another code number.
Refer to the remote-control code tables on the following
pages to find the appropriate code for your particular
component. If more than one number is listed, try each one
separately until you find the one that works.