Filter
Top Products
6 English English 6
English 7
Rear Panel
1.
Cooling Fan
• The fan always turns when the power is on.
Provide a minimum of 6 inches (15 cm) of
clear space on all sides of the fan when you
install the product.
2.
2.0 CH Speaker Connector Terminals
The speaker connector terminals are located
on the rear of the system.
1.
To achieve the correct sound quality, insert the
speaker connector cables identified below into
the correct speaker terminals on the back of
the system.
• Left speaker (marked L).
• Right speaker (marked R).
3.
ONLY FOR SERVICE
• This jack is for service only. Please do not
use.
4.
AUX IN 2 Terminals
1.
Use an
Audio Cable (not supplied) to connect
AUX IN 2 on the product to Audio Out on an
external analog component.
• Be sure to match connector colors.
• If the external analog component has only
one Audio Out jack, connect to either the left
or right terminal.
• Press the TUNER/AUX button to select the AUX
2 input.
• When the unit is in AUX mode, if none of the
buttons are pushed for more than 8 hours, the
power will automatically turn off.
5.
FM Antenna Connector Terminal
1.
Connect the FM antenna (supplied) to the FM
Antenna jack.
2.
Slowly move the antenna wire until you find a
location where reception is good, then fasten it
to a wall or other rigid surface.
3.
If reception is poor, you may need to install an
outdoor antenna. To do so, connect an outdoor
FM antenna to FM antenna jack on the rear of the
system using a 75Ω coaxial cable (not supplied).
6.
LED Terminals for the Front Speakers
To enjoy the special light effect of the speakers,
connect the LED cables of the Front Speakers to the
LED terminals of the system.
1
2
3
4
5
6