8
Disabling the buttons
The Lock button is used to prevent unintentional operation of your
receiver.
1. Press the Lock button to disable the buttons on the receiver. The
Key icon
will be shown in the top display panel. This will prevent
accidental operation when your receiver is packed in a suitcase or
travel bag.
This does not affect the Volume control, the Stereo/Mono
switch or the Waveband switch.
2. To enable the receiver buttons, press the Lock button again, this will
cause the Key icon
to be extinguished from the top display panel.
Switching on and setting the time zone
1. Place the unit on a flat surface. Make sure that the batteries have
been inserted correctly, or if using mains power, plug the mains lead
into a wall socket and switch on at the wall socket. The unit will beep
twice.
2. The display will flash the Home icon
and the number of the
current time zone.
3. Rotate the Zone control to select the city in your time zone. This
will change the time zone code displayed on the top screen. The time
zone codes are displayed with a world map on the rear of the unit.
4. Press the H.T.Z. button to confirm the time zone.
5. The display on the top screen will show the World icon
.
1
1
3
4
R9968 Issue 2.pmd 10/21/2005, 2:03 PM8