Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
14
Operating your radio - Search tuning FM
1. Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the On/Off button to switch on your clock radio.
3. Press the Band button to select the FM band, then repeatedly press
the Select button until "Auto tune" shows on the display.
4. Press and release the Tuning Up button. Your radio will scan in
an upwards direction (low frequency to high frequency) and stop
automatically when it fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. To fi nd other stations, press and release the Tuning Up button as
before.
7. To scan the FM band in a downwards direction (high frequency to low
frequency) press and release the Tuning Down button.
8. When the waveband end is reached your radio will recommence tuning
from the opposite waveband end.
9. Adjust the Volume buttons to the required setting.
10. To switch off your radio press the On/Off button.
2
3
7
4,6
9
9
10
3