Roberts Radio CRD-51 Clock Radio User Manual


  Open as PDF
of 32
 
11
Operating your radio – FM autotune
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the On/Off button to switch on your radio.
3. Press the FM/DAB button to select the FM band.
4. Press and hold down the Tuning Up or Down buttons until the
frequency in the display begins to change. Your radio will scan the
FM waveband, stoppingeach time itnds astation ofsufcient
strength.
5. After a few seconds, the display will update and show station name
if RDS informationis available.
6. Tondotherstations,PresstheTuning Up or Down buttons as
before.
7. When the end of the waveband is reached, your radio will recommence
tuning from the opposite end of the waveband.
8. Press the Volume Up or Down buttons to the set the required volume
level.
9. To switch off your clock radio press On/Off button.
1,9
3
4,6
4,6
8
8
 previous next