Roberts Radio CRD-36 Clock Radio User Manual


  Open as PDF
of 36
 
13
Operating your radio - Search tuning FM
1. Fully extend the wire aerial.
2. Press the
Standby button [On/Off button on the remote control] to
switch on your radio.
3. Press and release the
Function button until the FM band is se-
lected.
4. Press the
Skip Up button and then press the Auto scan button,
yourradiowillscaninanupwardsdirection(lowfrequencytohigh
frequency)andstopautomaticallywhenitndsastationofsufcient
strength.
5. After a few seconds the display will update. If the FM band is selected
the display will show the station name if available. The display will
alsoshow"St"and"RDS"afterthestationnameontheupperlineif
the station is with stereo and RDS function.
6. Tondotherstationspressandholdthe
Autoscan button as before.
7. ToscantheFMbandinadownwardsdirection(highfrequencytolowfre
-
quency)presstheSkip Down button and then press Auto scan button.
8. When the waveband end is reached your radio will recommence tuning
from the opposite waveband end.
9. Adjust the
Volume totherequiredsettings.
10. To switch off your radio press the
Standby button.
2
3
4
7
9
10
4,6,7
 previous next