Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Important Information - please read before use
To assist the auto setup of your clock radio it is recommended
that, before connecting your radio to the mains supply, to fully
extend the pig tail aerial on the rear of your clock radio and
place your clock radio in a position where radio reception is
best.
Note: The two LR6 (AA size) batteries provide power for
the clock/memory backup and must be fitted at all times.
Battery operation
1. Remove the Battery cover on the base of your CD clock radio by
pressing the tab on the cover and lifting in the direction of the arrow.
Insert 2 x LR6 (AA size) batteries into the spaces in the compartment.
Observe the correct battery polarity as shown inside the battery
compartment. Replace the battery cover.
2. Remove Battery cover on base of your remote control by rotating
the cover to the Open position. Insert 2 x LR03 (AAA size) batteries
into the spaces in the compartment. Observe the correct battery
polarity as shown inside the battery compartment. Replace the
battery cover.
Mains Operation
1. Place your radio on a flat surface.
2. Plug the mains plug into a wall socket and switch on the wall
socket.
1
2
6
Remote Control