Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Operating your radio - search tuning
1. Switch on your clock radio by pressing the BAND button on the
CD clock radio or the BAND button on the remote control.
2. Select the required waveband by pressing the BAND button on the
CD clock radio or the BAND button on the remote control.
The waveband selected will appear in the display. On FM fully extend
the wire aerial from the rear of your clock radio. On MW rotate your
radio for best reception.
3. Press and hold down either the Tuning up or Tuning down
buttons until the frequency in the display begins to change rapidly.
Release the button.
4. Your radio will scan the selected waveband, stopping each time it
finds a station of sufficient strength. Adjust the VOLUME control
to the required setting.
5. To search for additional stations repeat the above procedure.
Search tuning may be stopped by a single press on either the
Tuning up or Tuning down buttons.
6. The tone of your radio can be altered by adjusting the Tone control
on the right hand side of the unit.
7. Press the StandBy button to switch off your radio.
16
1
7
Remote Control
4
1
3
2
3
5
55
2
3
3
5
7
4
6