Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Automatic Plug and Play setup
When your Clock Radio is first connected to the mains supply or after
a power failure (when backup battery is not installed), the Auto setup
will proceed as follows:-
• Automatically search all wavebands and store stations in
presets.
• Automatically set the time and day of week.
1. Connect to mains (see page 6). Your radio will show "SEARCHING
FM PLEASE WAIT' followed by a Demonstration of the RDS features
available.
2. Your radio is ready for use when the Auto Time indicator stops
flashing.
3. The auto time indicator will flash in the display whilst time setting
is carried out.
4. If the first station detected by the automatic setup does not carry
Clock Time information your radio will automatically change to
another station after 1-2 minutes. This process will repeat until the
clock is set.
5. Press the Power button to switch on your radio and press one of the
Preset buttons to select a station. Adjust the volume using the
Volume control. To switch off your radio press the Power button.
Note:- Auto setup can take up to 5 minutes to complete and is
dependent on the signal strength and number of stations in your
area.
To interrupt the Auto setup press and release the Memo button.
Should Auto setup fail, setting the clock and pre-setting stations can
be carried out manually as described in the following sections.
2
5
5