Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
6
Operating your radio - DAB
1. Carefully extend the telescopic aerial.
2. Press the On/Off button to switch on your radio, the display will show
'WELCOME' for a few seconds. After each use the radio will remember
the mode used and then switch on in that mode the next time that it
is used.
3. If this is the fi rst time the radio is used a quick scan of the Band III
DAB channels will be carried out. This is known as 'Auto tune'. If the
radio has been used before the last used station will be selected.
4. During Auto tune each group of stations will be detected and the station
count will be updated.
5. When the Auto tune is completed the fi rst station (in numeric-alpha
order 0...9...A....Z) will be selected. The fi rst station in the list of stations
found will be played.
6. If no stations are found then 'OFF AIR' will be displayed and it may be
necessary to relocate your radio to a position giving better reception.
You should then carry out an auto tune to fi nd stations as described
on page 9 (see Finding new stations on page 9).
• Your radio has an indicator
on the display to indicate the strength
of the DAB radio signal being received.
Note: When fi rst switched on, the radio will set the volume to a moderately
high level, in case the broadcast is very quiet. After you have set the volume
using the Volume control, the radio will remember the setting that you
have applied for the next time that it is used.
2